Wall mounted rectifier IP54 water cooling 480V 3ph AC input
How to do wall mounted rectifier?
Our professional design, with special consideration of pressure to all inside components.
1). Front panel with:
2). Bottom side:
DC ouput +-,
Water pipe inlet and outlet,
Remote control interface,
3). Top with AC input.
4). Here is the dimension drawing:
1. AC Input
Input AC phase
3 phase 4 line(A,B,C,N)
Input line voltage(V)
2. DC Output
Output mode and range
Constant Current, 0-100% of rated value
Constant Voltage, 0-100% of rated value
100% full load
<3% of rated value
3. Electrical Features
Power Factor(Full load)
B, please specify if you require higher
Audible and visual alarm
3. Cooling water requirement
Water is not corrosive, dirty or contains acids.
Inlet Water Temperature
To prevent condensation, the water must not be too cold.
Inlet Water Pressure
Not less than 15L/min.
Over/under input voltage protection
AC input under voltage 430V, over voltage 520V
IGBT module CE voltage abnormal
or IGBT damaged
Over heat protection
Over current protection
Inlet water<0.03MPa, alarm.
Inlet water pressure<0.02MPa, alarm and stop running
Or you could set protection value on touch panel
5. Green Power Rectifier Quality-the basis of process reliability
We provide top quality, high reliability, low fault rate of rectifiers, ensuring your line smooth and continuous running.
Components used are all good quality and excellent performance:
1. Control board: DSP digital control, 20+ years high control accuracy, not like analog control, accuracy will reduce after some time.
2. Cabinet: use 2mm thick strong cold-rolled steel plate or aluminum coated zinc plate.
3. High frequency transformer: Nanocrystalline material as transformer core, high efficiency saving power, long time reliable running.
4. Bus bar: red copper bus bar, the purity of copper is 99.9%, tin plated, not like others may use brass or aluminum inside.
5. Cooling fan: use Taiwan or Japan brand high quality fan, with lifespan 100,000 hours under 25℃.
6. Touch panel: control and display all parameters on one panel for local use or remote monitor, say goodbye to separate controls. easy for troubleshooting, while there is protection, it will show protection type automatically.
7. Capacitor: Taiwan brand reliable capacitors.
8. IGBT: Germany or Japan brand.
9. SMPS: Taiwan brand.
10. Rectifier diode module: good quality brand.
11. Current sensor: good quality brand.
12. Cables, wires, screws: good quality brands.
6. Control parameters on touch panel
|Input to rectifier:||Output from rectifier:|
|Set current||Actual current|
|Set voltage||Actual voltage|
|Set control mode (CC/CV, local/remote)||Run mode(CC/CV, Local/remote)|
|Set run time||Alarm signal|
|Set pulse time||Alarm cause|
|Set manual/auto||Run time|
|Emergency stop||Ampere hour|
|Set rectifier-stop delay time||Water pressure(for water cooling)|
7. 1000A 18V Rectifier Operation Conditions
Power requirement: AC nominal voltage+/-10%, 3 phase 4 line, 3 phase imbalance less than 5%, and meet national electricity quality standard.
Saturated vapor pressure: daily average value is less than 2.2X10-3M pa, monthly average value is less than 1.8×10-3Mpa.
Strong R&D ability. If you have special requirement, we will do Custom design for you.
Looking for Wall Mounted 1000A 18V Rectifier IP54 Water Cooling 480V AC Input? Green Power Technology is one of the professional manufacturers and suppliers. We have been dedicated to this field for over 20 years and already exported products to India, USA, Germany, etc. Equipped with a productive factory, we warmly welcome you to buy our high quality products made in China at competitive price or try our customized service.