Application:
For EDT Coating rectifier, Green Power provide 500A300V EDT Coating Rectifier Wholesale.
Rectifier 3 Solutions Topology:
It's depends on output power, voltage and other technical requirements;
1. Thyristor rectifier
2. IGBT switch mode rectifier
3. IGBT chopper rectifier
Rectifier Technical data:
Input voltage | 220V/380/415V/480V AC ±10% 3 phase 4 line, 50-60Hz |
Rated output voltage | 500A, Could custom design |
Rated output current | 300V, Could custom design |
Output range | 0-100% |
Control Accuracy | ≤0.5% |
Power factor | ≥0.94 |
Efficiency | typical 90% at rated output |
Current ripple | <5% at rated output,low ripple in whole range |
Control mode | constant current/constant voltage |
Cooling | Air cooling or water cooling |
Protection class | IP32 for Air cooling,IP44 for Water cooling |
Insulation grade | B |
HMI | Touch Panel on control box |
Remote control interface | Standard RS485, Profibus, Profinet, 0-10V/4-20mA available |
Alarm type | Audible and visual alarm |
Protections | Output overcurrent protection |
Over heat protection | |
IGBT Driving protection | |
Features | Digital DSP control(USA TI DSP Chip) |
History date record function | |
Waveform function | |
History protection record function | |
Timer | |
Anticorrosion treatment | |
Ambient temp | Max. 40℃, derated operation up to 50℃ |
Altitude | ≤2000m altitude. De-rated operation if higher |
What is EDT Coating?
Electrocoating, which is also referred to as electro deposition, electrophoretic deposition, CED Coating, CED Painting or electropainting, is an organic finishing process that uniformly applies thin-film primers and one-coat finishes to metallic substrates. Electrocoating resembles electroplating in that it utilizes an electrical current to deposit a coating onto substrates. However, electrocoating deposits water born paint onto substrates rather than metal ions.
EDT Coating Process:
The electrocoat process can be divided into four distinct steps:
1. Pretreatment
2. CED/Electrocoat Bath
3. Post Rinses
4. Baking