Application This is 2500A18V Constant Current/Voltage DC Power Supply for Electrolysis , water cooling, 3 modules in parallel, 2500A18V*2+1000A10V*1 module structure. Specification Working condition Cooling water requirement: l Used indoors, ambient temperature: 0℃ ～ + 5 0℃. l Relative humidity:...
This is 2500A18V Constant Current/Voltage DC Power Supply for Electrolysis, water cooling, 3 modules in parallel, 2500A18V*2+1000A10V*1 module structure.
IGBT High Frequency Rectifier, Modular Structure, Easy for Maintenance
100% 24 hours continuous running
|AC input||3 phase 220V/380V/440V/480V|
Output Regulation Range
|0 ~ 100 %|
Soft start time settin
Constant current/constant voltage selectable
Auto(control by PLC through MODBUS RS485 Interface) & Manual(control by control box)
Remote control interfac
Touch Panel on control bo
Over heat, over current, voltage limit, short circuit, input over/under voltage protection, IGBT driving protections
resistivity ≥20KΩcm, hardness<8 dH
Water is not corrosive, dirty or contains acids.
Inlet Water Temperature
To prevent condensation, the water must not be too cold. The ideal temperature is between ambient temperature and 35℃(not below dew point)
Inlet Water Pressure
l Used indoors, ambient temperature: 0℃～+50℃.
l Relative humidity: ≤90% (relative to 20±50℃).
l Elevation: less than 2,000 meters.
l There shouldn’t be excessive amount of dust, explosive and corrosive gas in the air.
l The installation place should be without severe vibration, the vertical gradient shouldn’t exceed 5%.
l The seismic intensity of the installation site is less than 7 on the Richter scale.
l Saturated vapor pressure: daily average value is less than 2.2×10-3M pa, monthly average value is less than 1.8×10-3Mpa.